When I set in ptokax an minshare of 25Gb it change to 0 after a while. The max share is is good but its only at the min share.
Do I something wrong or is this a bug?
grts,
Vipertje
it could be one of your scripts doing that
i did chk it again and I find out that it change evrytime I restart all the scripts :S what could it be? RoboCop?
yes it sounds like robocop, have a play around with 'enable inbuild slots/hubs' in the settings of robocop.
Hmmmm, what must I do to fix this?
Well I already explained, but I assume I didn't go into enough detail.
Go to the scripts folder
Open RoboCop.exe
Under settings tab > Options, check the box which says 'enable inbuild slots/hubs'
Close robocop.
Select restart scripts in ptokax.
This is all assuming it's a correct diagnosis of the problem. You do use robocop right?
Report back on your progress.
what you can do? Hmmm, easy, use an uncompiled bot
Quote from: imb on 02 June, 2007, 02:48:07
Well I already explained, but I assume I didn't go into enough detail.
Go to the scripts folder
Open RoboCop.exe
Under settings tab > Options, check the box which says 'enable inbuild slots/hubs'
Close robocop.
Select restart scripts in ptokax.
This is all assuming it's a correct diagnosis of the problem. You do use robocop right?
Report back on your progress.
THX m8, I think that was it :) I feel stupid :S that I didn't see that :S but many THXs
Not a bug, locking.