I have a Pentium 1 166 Mhz
128 MB RaM memory.
Only Ptokax is running on that pc.
I get still the connection reset message.
What could it be.....
To low Mem.???!!
QuoteOriginally posted by [NL]Portal
I have a Pentium 1 166 Mhz
128 MB RaM memory.
Only Ptokax is running on that pc.
I get still the connection reset message.
What could it be.....
To low Mem.???!!
hmmmmmmmm, running firewall?
and any scripts?
I am running a 2 pc here , 1 server and one personal.
The one where is ptokax is running , is on the Pentium 1 166 Mhz 128MB RAM memory..
And i am running on a router Kobishi.
Ports open
411 TCP\UDP
412 TCP\UDP
1412 TCP\UDP
413 UDP
Good configuration of the router ???
Please message back
hmm not to sure about that sorry, maybe w8 til plop or someone thats knowledgable of setting up routers,
I assume you use NAT on the router?
If you use NAT can you try to stay connected to the private address to check if the connection reset only occur when going through the router?
If using NAT and reset only occur when going though the router then there could be timeouts of the NAT entries on your router that cause the problem. On many router you can see the NAT entries and the timers, but i'm not familiar with the router you got.
QuoteOriginally posted by [NL]Portal
Ports open
411 TCP\UDP
412 TCP\UDP
1412 TCP\UDP
413 UDP
I use only the utp protocol for the hubs and both for my own connection to the hub. I connect to the hub with the local ip pc adres,where the hub is running on.
example:
external ip: 80.80.80.80
2 pc's
pc1 192.168.4.1
pc2 192.168.4.2
pc1 is running the a hub on internal port 411 and external port 411 is used to let people enter.
pc2 is used to use dc / connect like a user to the hub
then in the router:
internal ip: 192.168.4.1 internal port: 411 protocol: tcp
external ip 80.80.80.80 external port: 411 (this part is different for each router brand, it is possible you haven't got to enter the external ip)
internal ip: 192.168.4.2 internal port: 1412 protocol tcp and utp external ip: 80.80.80.80 external port: 1412
When connecting like a user to the hub:
general connection settings:
active / 80.80.80.80 / port: 1412
connect to the hub:
hub adress: 192.168.4.1:411
Good luck
[NL]MrBuitenhuizen