PtokaX forum

PtokaX => Support => Topic started by: CrazyGuy on 03 April, 2008, 19:39:48

Title: PtokaX Service Installation Wizard
Post by: CrazyGuy on 03 April, 2008, 19:39:48
PtokaX will soon be available in a gui-less version that can be started from the command prompt or as Windows Service.
Beta testing of this version shows that a minor setup is needed before you can use this functionality.
Most settings are changeable by script, but a few are mandatory to start the hub.

I've written a small simple program that allows you to set these settings.
It will also use PtokaX' own commands to register itself as a Windows Service, and after setup, the hub can be started.
Attached is an image and the program
Note: you can run the program from anywhere you want, but you will need a clean installation of a version of PtokaX without GUI unpacked.
Title: Re: PtokaX Service Installation Wizard
Post by: zygott on 03 April, 2008, 20:39:26
fantastic work... a much needed addition to the service form of ptokax :)
Title: Re: PtokaX Service Installation Wizard
Post by: Madman on 03 April, 2008, 20:49:11
Nice work CG
Title: Re: PtokaX Service Installation Wizard
Post by: Tw?sT?d-d?v on 03 April, 2008, 21:36:14
Nice work  ;D ;D
Title: Re: PtokaX Service Installation Wizard
Post by: TrIp-iN-SuN on 04 April, 2008, 13:29:09
good work :P:P
Title: Re: PtokaX Service Installation Wizard
Post by: CrazyGuy on 06 April, 2008, 12:28:37
As PtokaX 0.4.1.0RC2 has a change in service install commands, I had to make a new version as well.

Attached is version 1.1, compatible with RC2

April 21st 2008 Edit: Download version 1.2 below instead  :)
Title: Re: PtokaX Service Installation Wizard
Post by: Psycho_Chihuahua on 07 April, 2008, 18:08:31
added a link to my ptokax mirror (http://www.ptokax.ath.cx) refering to this thread :D
Title: Re: PtokaX Service Installation Wizard
Post by: CrazyGuy on 11 April, 2008, 12:26:14
Cool thnx  ;D
Title: Re: PtokaX Service Installation Wizard
Post by: CrazyGuy on 21 April, 2008, 13:40:45
Updated to version 1.2



Specifying the sub-directory will remain optional, as this is also the case in manually registering and setting up PtokaX.
Leave the field blank to set up hubs pre 0.4.1.0RC4 or if you don't want to use this feature  :)


Test info :
Tests performed by Psycho_Chihuahua ( thnx  ;D )