Print Page - disconnecting users

Title: disconnecting users
Post by: xokas on 28 October, 2003, 03:20:34

hi! i get this problem in ptokax! can someone help me out here? the problem is: [BUF] [PT]Patuga@home SendBuffer overflow. User disconnected and then disconnect's the user! can someone help me here?

Title:
Post by: Nedvev on 28 October, 2003, 06:00:15

If you use the option "keep slow clients online", you will get something like this:

[BUF] che 1. SendBuffer overflow. Buffer cleared - user stays online.

That will do. :)

Bsk.:

Title:
Post by: lazyj189 on 28 October, 2003, 08:38:34

ya, what I wanna know is what causes that to happen. Is it the fact that there is a bad connection between the client and the hub, or just that the hub has piss poor bandwidth?

Title:
Post by: klownietklowniet on 28 October, 2003, 09:19:32

I'm not sure.. but I think it has to do with timeouts.. and that can be due to poor connection aswell... or just a bad connection at a certain point...

Title:
Post by: ptaczek on 28 October, 2003, 09:51:41

The buffer overflow happen if the client (or hub) is unable to handle the dat throughput generated by the hub (by the client).

few reasons:

a) the hub's connection is maxed out
b) the client's connection is maxed out
c) there is some temporary drop-out on the link between hub and client

and variations of that above.

Title:
Post by: xokas on 28 October, 2003, 15:15:53

i've seen another stuff bout the [13:54] [BUF] [PT]Patuga@home SendBuffer overflow. User disconnected. !

when i was using the BlackDC this happened! and then i close it and never happened again! could it be related?maybe a bug on ptokax caused by BlackDC? will wait a replye bout it! tkhx all! xokas over & out

Title:
Post by: Pieltre on 21 April, 2004, 21:30:08

Hi,

I have this problem with very few users and most of the time, it works out correctly. Only one user keep getting an overflow and a subsequent disconnection, but for some reason he can't reconnect... The hub disconnects him, but his session is kept alive for hours after that. What could be causing this? Btw, I did enable the 'keep slow clients online'

regards,
Pieltre

Title:
Post by: plop on 22 April, 2004, 15:53:28

QuoteOriginally posted by Pieltre
Hi,

I have this problem with very few users and most of the time, it works out correctly. Only one user keep getting an overflow and a subsequent disconnection, but for some reason he can't reconnect... The hub disconnects him, but his session is kept alive for hours after that. What could be causing this? Btw, I did enable the 'keep slow clients online'

regards,
Pieltre

tell him 2 start using bcdc++ and limit his upload a tiny bit.
if he has 25KB/s up then set the limiter to 22KB/s.
should solve his problem.

plop

PtokaX forum

PtokaX => Support => Topic started by: xokas on 28 October, 2003, 03:20:34