PtokaX > Support

PtokaX Service Installation Wizard

(1/2) > >>

CrazyGuy:
PtokaX will soon be available in a gui-less version that can be started from the command prompt or as Windows Service.
Beta testing of this version shows that a minor setup is needed before you can use this functionality.
Most settings are changeable by script, but a few are mandatory to start the hub.

I've written a small simple program that allows you to set these settings.
It will also use PtokaX' own commands to register itself as a Windows Service, and after setup, the hub can be started.
Attached is an image and the program
Note: you can run the program from anywhere you want, but you will need a clean installation of a version of PtokaX without GUI unpacked.

zygott:
fantastic work... a much needed addition to the service form of ptokax :)

Madman:
Nice work CG

Tw?sT?d-d?v:
Nice work  ;D ;D

TrIp-iN-SuN:
good work :P:P

Navigation

[0] Message Index

[#] Next page

Go to full version