Author Topic: help  (Read 1802 times)

0 Members and 1 Guest are viewing this topic.

Offline Dobro

  • Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
« on: 03 December, 2003, 23:27:10 »
i dont know where else too put this thread but ill give it a shot here

now too my question

can someone tell me the basics too make an dc hubb im clueless??

PtokaX forum

« on: 03 December, 2003, 23:27:10 »

Offline SaintSinner

  • Lord
  • ***
  • Posts: 293
  • Karma: +1/-0
(No subject)
« Reply #1 on: 04 December, 2003, 00:00:23 »
ok since i am a nice guy and i
dont want you to get flamed becouse this should have
been posted in the Discussion / Help, or offtopic, this thread is for scripts and there has been too much annimosity/hate in here today. so here goes:

-download the hubsoftware here
-pick out a script like robocop or channelbot or something that is to your liking, but i think you will want to start with just the basics so the built in commands will do until you learn more but if you want a script.
you can find them in the scrpit section here
-extract the contents to the script folder of ptokax
scripts should be "name.lua"
-read the readme file for the script it ususally contains the command you will need to use and setting it up
-start the hubsoftware up by clicking of "ptokax.exe"
-go to the ops and bans tab
-op/admin or master yourself
-go to "network settings"  give your hub a description
and get a dns service like no-ip, put your in your "Hub address"
click on "start hub"
-start your direct connect client up and connect to
address<---that is your internal ip address
and you should be able to connect to it or you can use
your address.

that is a basic rundown that should get you started.
hope that helps.

PtokaX forum

(No subject)
« Reply #1 on: 04 December, 2003, 00:00:23 »